8 models of plates 3 Rollers Animal Feed Pellet Mill Machine

1.The machine not be used for wood chips.

2.If the feed material is hay, do not add the hay directly to the machine, mix the hay with the wet grass and add it to the machine. Avoid hay clogging the machine resulting in burning the motor.

3. Before using the machine, it is necessary to adjust the screw of the pressure roller to the appropriate position. The pressure roller and the pressure plate should be closely combined, and the three adjusting screws should be on the same horizontal plane.

4. Please refuel the fuel tank before using the machine. The machine should not idle for more than 2 minutes.

5.Double-check the belt and the screws before operation.

6.Clean up the rest after use to prevent damage to the machine.

7.If the pressure roller cannot rotate normally, please tighten the screws that control the pressure roller first, and then try to power it on. If it still does not work, you can appropriately loosen the screws next to the pressure roller and then tighten them slightly again (without special tightening)

 Adjustable nut Used to adjust the distance between the pressure roller and the grinding disc. When making pellets, the nuts on the three sides must be balanced to avoid damage to the pressure roller and grinding disc.

If the pressure roller cannot rotate normally, please tighten the screws that control the pressure roller first, and then try to power it on. If it still does not work, you can appropriately loosen the screws next to the pressure roller and then tighten them slightly again (without special tightening)

After using the machine for a period of time, the customer needs to add butter to lubricate the grinding chamber here (approximately 4-6 months of use) (the butter gun and butter need to be purchased by the customer themselves, and we do not provide them).

  We suggest that high-power machines should be directly connected to the main power supply, as the voltage reaching the machine is stable. If the voltage is unstable and the current exceeds the rated current of the motor, it is easy to burn out the starting capacitor.

It is recommended to directly connect to the power supply as much as possible. If the machine is not connected to the power supply, different situations may occur, and the wires are not durable. The wires will gradually burn out over time.