The Dead Water Finisher is a gold concentrate vibration finisher designed in the United States by Prospector Tripp. This innovative product is used for cleaning up gold concentrates. This is a terrific interactive hobby mining tool that is loads of fun to operate while cleaning your gold concentrates. With its frequency-controlled vibration technology, the Dead Water Finisher ensures precise frequency controlled "gold walking" out of your cons, making it a super fun, enjoyable interactive finishing tool.

Built with quality and precision in mind, this product is a valuable tool for those in our crazy fun hobby mining industry looking to improve their overall fun and enjoyment while finishing your gold concentrates.

Comes complete, ready to run out of the box with batteries included and installed. 

I personally build and test every single unit to ensure that they function properly.

You will need.. regular ac household power,  a suitably sized wash tub (14x12x4 inches is large enough) set on a flat surface, like a kitchen table or work bench. Add about 1 3/4" of water and a shot of Jet Dry.

Plug it in (you may have to prime the 160gph fountain pump) place a small amount of your gold concentrates in about the middle of the wash plate. Switch on the power in the back. Then, adjust the speed controller until the gold begins to move upward. I have found that about at setting #2 is enough to get things moving. Snuffer up the clean gold as it climbs out of your cons. Adjust the frequency as necessary as well as brush your cons back to the center of the wash plate.  Keep snuffering up the clean gold until complete. As you get most of the gold removed, you may want to lift the backside of the Dead Water Finisher a few milliliters and wash off some of the dirt and magnetite to free up the possible fine gold remaining. You may also want to turn off the vibration during the last of the fine gold finishing. I have found with the vibration on while working on fine gold it will cause this super fine gold to move too easily and make getting the last remaining specks of gold out of the black sand more difficult. 

Please experiment and have fun learning this terrific tool. I have really enjoyed using this finisher.

You will likely enjoy it, too!

It is a blast! 100%

The Dead Water Finisher is roughly 6x9x5 inches.

Lastly.. this unit is manufactured from 3d printing PLA filament. PLA needs to be cared for and can not take excessive heat or direct sunlight on a hot day for very long. This unit is basically an indoor tool as it requires AC household power for the pump. If cared for the Dead Water Finisher will last for years of fun and enjoyment. It also has an electric speed controller that can not be doused in the water. Please be careful not to get it wet or submerge it, or the electronic speed controller will likely fail.

Stay Golden ⚡️

Peace Prospector Tripp