The resin specially designed with Low viscosity, convenient 2:1 mix ratio by weight, long pot life, room temperature curing system with great clarity and a high gloss finish.
can deeper pour up to 2"-4" one time in winter
12kg / 3 Gallons kit : 2 bottles 1 Gallon/128oz resin A + 1 bottle 1 Gallon/128oz hardener B (Total 3 Gallons / 12kg)
Tips for operation
each time the resin mixed with a thickness range of under 2" in summer, 2-4" in winter to avoid bursting.and you can go as deep as you like, just make sure to work in stages. stay under 2"- 4" per pour. After the surface film cures begin your second pour.
the surface set time is roughly 4 hours at room temp.
Full cure time is 48 hours in Summer, 48-72 hours in Winter. Hardness range 80-85D
This product cures to a brilliant high gloss finish. The finished product will be very rigid, smooth, clear, and display a brilliant high gloss finish similar to glass.
Formulated to meet a variety of applications.
Perfect for tabletops, fiberglass work, small castings (under 4"), electrical potting, jewelry making, concrete - pebble coating, marine applications- boat building, & wood water proofing - repairs.
Features:
Mix Ratio...............2:1 by weight
Work time ..............4-6 hours
Hardness....................D80-85
Mixed Viscosity..........2000-3000cps.
Chemical Resistance.......excellent
Moisture Resistance........excellent
FDA Compliant / Food grade: Yes, in its inert fully cured state
Heat resistance: up to 80℃ (please don't leave hot pans on it,a coaster needed)
Approximate Coverage: 12 square ft per 4kg/1 Gallon at 1/8 inch thickness
Operation steps
2:1 ratio for A & B glue by weight
Pour into the mixing cup
Along the cup wall and bottom stir it evenly for 2-3 minutes
Add glitter or pigment if you need, then stir it, standing 30-60s
Slowly pour mixed resin down the mold
Add other decorative
APPROVED APPLICATIONS:
WOOD & METAL COATING
TABLETOPS
CRAFTS
JEWELRY MAKING
HOBBYIST AND CRAFT MAKING
PLAQUES AND FRAMES
CONCRETE AND PEBBLE COATING
FIBERGLASS WET LAY-UP
WATERPROOFING & SEALING
Important
This chemical needs to be stored in a dry, safe, temperature controlled environment. Always keep the lids tightly sealed when not in use.
Remember, oxygen and moisture oxidize and can rapidly degrade the epoxy and hardener. Moisture is also a potential issue. Always keep the bottles sealed when not in use.
When applying this product, use gloves, goggles, and proper safety equipment. Please refer to the safety data sheet before using any of our epoxy products.
0 Comment
Leave Comment